How to factory reset a Cisco Router/Switch via Rommon
To reset some Cisco routers and switches, you need to enter ROMMON mode. To get into ROMMON, you can
Netlogon not appearing
Was able to get the NETLOGON share to appear. This took a bit longer than usual as I;ve not seen it
Enabling LACP between two switches (Port Channels)
This configuration needs to be done on both switches. In this example, we making GigabitEthernet0/1
Enabling Layer 3 switching on a Cisco switches
Step 1.
If you have a layer 3 Cisco switch and want to route packets via different VLANs, you need t
Configuring Inter VLAN routing on Cisco devices (Router on a Stick method)
This is a quick write up on how to configure inter VLAN routing in Cisco IOS. This guide is mainly t